Blink R536 Manuel de service télécharger pdf

KB2LJJ Radio Mods Database and Manuals

Mods TM-733

TM-733 Japonise version Cross Band Repeating

Cross band repeat isn't documented but comes ready from the factory.

To enable cross band repeat from the front panel, first select a band by pressing BAND SELECT. Then, change the control to

the other band by hitting [CONT SEL]. Next, press [F] for one second, then the "X" button (far right side). Decimals will

appear between the Kilohertz digits, and the "ON" indicator will light momentarily. The microphone sequence to enable cross

band repeat while in remote control mode is "DC".

The transmitter hang time can be toggled between 500ms to 0ms by turning on the radio with [LOW] pressed. They also

recommend enabling the Time-out Timer, for obvious reasons.

TM-733 can also be used as a "one-way" cross-band repeater.

For example, if you can receive a distant repeater with your HT, but have difficulty getting into it, you can use the TM-733 to

boost your transmitted signal. To set this up, just omit the part where you "change the control to the other band by pressing

[CONT SEL]." Doing this will setup the TM-733 to repeat your signal to the other band, but will not retransmit the distant

station back to you. If this sounds ambiguous, play around with it a little and it will begin to make sense.

TM-733 with 2 antenna-sockets

Note that the

As I started to use the TM733E on my 3 bander COMET 901 , I had to modify my transceiver. As I think some off you use a 3 way splitter to

connect several transceivers at the same time there was a problem,I could not use the 23cm band and the splitter anymore sinds the TM733E

came with only one antenna socket (mixed VHF and UHF).

After looking around in different shops, I was unable to find a splitter that had the UHF and VHF together on one socket and the 23cm band on

another.

So I decided to have a look at the schematics off the TM733E and noticed the US version has 2 antenna sockets.

Modifying the rig is very simple:

Make a second antenna cable with PL259 socket or get it at your local Kenwood dealer (some 15$) (same cable as on the other mobile dual

banders ...TM701 etc.)Open both sides off the transceiver.

Take off the plastic cover off the spare hole at the back.

Insert and solder the new antenna cable.

Take away the connection (one big pin) from the VHF to the UHF pc-board with a good solderpump.

Your rig has now 2 antenna-inputs ,one for VHF ,one for UHF.

This mod. is also interesting for those who often use the CROSSBANDREPEATER, sinds you can now connect a vertical to the 70cm tx and a

beam to the 2m part or the other way round.

Good luck with the modification and ...

have as much fun with the TM733E as i do !

73 de Jan ON1BJC @ ON4ABG

TM733 and 9k6 Bps

As I first started to use the TM733E on 9600Bps ,it didn't work very well.

Rx 9600Bps was no problem but the TX-side was poor in transmission-speed.

http://www.kb2ljj.com/data/kenwood/TM-733.htm (1 di 9)30/08/2009 18.42.07



www.r6-ru4montesecchieta.it

IZ5CCV

1 2 3 4 5 6 7 8 9

Résumé du contenu

Page 1 -

KB2LJJ Radio Mods Database and Manuals Mods TM-733 TM-733 Japonise version Cross Band Repeat

Page 2

KB2LJJ Radio Mods Database and ManualsAfter having a look at the SERVICE MANUAL i discovered that the audiosignal from the G3RUH should at least be 2

Page 3

KB2LJJ Radio Mods Database and ManualsPlease send me a message with your results. Good success!vy 73 Norbert DC6BC @ DB0IZ.#NRW.DEU.EU MODS OF KENWOO

Page 4

KB2LJJ Radio Mods Database and Manuals[F] (1s) PRESS AND HOLD [F] FOR ONE SECOND. "F" THEN BLINKS.[KEY] (1s) PRE

Page 5

KB2LJJ Radio Mods Database and ManualsMEMORY WRITING (ODD SPLIT) (RX FRQ),[F],[MR] (1s),(TX FRQ)[MR]MEMORY WRITING (SIMPLEX, DUPLEX)

Page 6

KB2LJJ Radio Mods Database and ManualsJust to the right of a chip labeled XRU4066BCF and just to the left of two green wires (B2 & B3 which are dr

Page 7

KB2LJJ Radio Mods Database and ManualsDTMF Paging and SquelchThe DTMF Paging & DTMF Squelch protocol (AAA*BBB) is compatible with the Yaesu 530 an

Page 8

KB2LJJ Radio Mods Database and Manuals TX-RX Unit (X57-4360-00) Foil Side View---------------------------------------------------------------

Page 9

KB2LJJ Radio Mods Database and Manuals● To begin remote control, you should key the external radio and press the following key sequence: "Axx

Commentaires sur ces manuels

Pas de commentaire

Blink R536 Manuel de service

Naviguer en ligne ou télécharger Manuel de service pour Les radios bidirectionnelles Blink R536. Blink R536 Service manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels